At the command prompt on PC3, type nslookup The command should generate the following output: PC> nslookup Server: To generate DNS requests directly from the server, use the nslookup command.Ĭ. So far all the DNS requests were done automatically by other applications. This verifies proper operation of the DNS server. Note that the domain name was translated by the DNS server to the IP address for the webserver, 192.168.3.100. Minimum = 138ms, Maximum = 172ms, Average = 151ms Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), At the Command Prompt on PC3, ping The command should generate the following output: PC> ping Pinging 192.168.3.100 with 32 bytes of data: To verify the resolution, close the Web Browser window on PC3.ī. DNS is used to resolve domain names to IP addresses. Step 3: Verify connectivity to the web server using DNS.Ī. The output of the command shows the ICMP packets generated by the tracert command traveling across the WRS_LAN interface to the host, PC2.Ĭ. Tracing route to 192.168.1.12 over a maximum of 30 hops:ī. The command should generate the following output: PC> tracert 192.168.1.12 At the command prompt, type tracert 192.168.1.12. From the Command Prompt of PC3, verify the path to PC2 using the tracert command.Ī. The tracert command is used to determine the path between a local host, in this case PC3, and a remote host. Step 2: Verify connectivity and the path between PC3 and the rest of the network using the tracert command. From the Command Prompt window, ping PC1 using its IP address of 192.168.1.11. Minimum = 78ms, Maximum = 203ms, Average = 117msĬ. Packets: Sent = 4, Received = 4, Lost = 0 (0% loss)Īpproximate round trip times in milli-seconds:
![test connectivity packet sender test connectivity packet sender](https://s3-eu-west-1.amazonaws.com/qt-showroom/uploads/2016/11/packetsenderscreenshot_ubuntu-768x569.png)
The command should generate the following output: PC> ping 192.168.2.1 From the Command Prompt window, ping the default gateway for PC3. Connect PC3 to the WRS_LAN network with the ITEpassword Pre-shared Key.ī. Step 1: Connect PC3 to the wireless LAN and verify connectivity with the ping command.Ī. You will also use various tools to test the functionality of the network. In this activity, you will configure PC3 to connect to the network via a wireless router. Configure a computer to join a wireless network.8.1.2.15 Packet Tracer – Test a Wireless Connection (Answers) Topology